Lanier Printer Accessories PSW 6 User Manual

Lanier Worldwide, Inc.  
2300 Parklake Dr., N. E.  
Atlanta, GA 30345-2979  
Emergency Telephone: (800)526-4371  
MATERIAL SAFETY DATA SHEET  
Section 1: Chemical Product and Company Information  
Identity:  
Product ID: 117-0237  
MSDS No.  
Issued: 01/05/98  
Toner for 9060 POD  
CP-312  
Supersedes:  
none  
Synonyms  
Date:  
01/26/98  
& Common Toner, Black Tonerer for Lanier  
Names:  
9060 POD  
Prepared by:  
Lanier QA/EH&S Department  
Uses:  
9060 POD  
European  
Contact:  
Lanier Worldwide, WSM Europe,  
Walter Fricke,  
Im Taubental D-41468 Neuss,  
Germany +49-2131-387-177  
Chemical  
Formula:  
Mixture  
Section 2: Composition / Information on Ingredients  
PERCENT  
CAS No.  
1333-86-4  
75214-60-7  
EXPOSURE LIMITS  
SOURCE  
3.5mg/m3 3.5mg/m3  
OSHA PEL ACGIH TLV  
Carbon black  
Polyester resin  
Polyester resin  
6 - 8  
not listed  
Trade Secret No.  
80100252-5001-P  
not listed  
n/a  
n/a  
<94  
TSCA Confidential  
Wax  
Pigment  
9003-07-0  
31714-55-3  
n/a  
n/a  
not listed  
*PEL as the product: 15mg/m3 (total dust), 5mg/m3 (respirable dust)  
*TLV as the product: 10mg/m3 (total dust), 5mg/m3 (respirable dust)  
Section 3: Hazards Identification  
Hazard Rating:  
FIRE = 1  
HEALTH = 1  
REACTIVITY = 0  
SPECIAL = none  
Health Hazards (Acute, Chronic, Immediate and Potential): Minimum irritation to respiratory tract may occur as with exposure to any  
non-toxic dust. May cause gasping if inhaled. Inhalation should be avoided. May cause temporary eye discomfort.  
Health Hazards of Long Term exposure (Chronic): A manufacturer sponsored chronic inhalation study in rats using a special test  
toner revealed there were no lung changes at all in the lowest exposure level (1mg/m3), the most relevant level to potential human  
exposures. A very slight degree of fibrosis was noted in 25% of the animals at the middle exposure level (4mg/m3), while a slight  
degree of fibrosis was observed at the highest exposure level (16mg/m3) in all animals. These findings are attributed to “Lung  
Overloading”, a generic response to excessive amount of any dust retained in the lungs for a prolonged interval. The special test  
toner was ten times more respirable than commercially available toner to comply with EPA testing protocol and would not function  
properly in Xerographic equipment.  
Section 4: First Aid Measures  
Remove to fresh air if effects occur. Consult  
local medical personnel  
Inhalation:  
Eye Contact: In case of contact, immediately flush eyes with  
water for 5 minutes.  
Ingestion: Dilute stomach contents with water. Call a  
physician  
Skin Contact:  
Wash with soap and water.  
Section 5: Fire Fighting Measures  
Suitable extinguishing media: CO2, dry chemical, foam or water.  
Extinguishing media which may not be used for safety reasons: none  
1
 

Kyocera Cell Phone K490 User Manual
Lantronix Switch LMS8 A User Manual
LG Electronics Computer Monitor W2241T User Manual
LG Electronics Lawn Mower 29UB65 User Manual
Lincoln Electric Welder SVM156 A User Manual
Linksys Network Router RV0041 User Manual
Magnavox Flat Panel Television 20MF500T User Manual
Makita Staple Gun AT1150A User Manual
Matsui America DVD Recorder DVDR100 User Manual
Meridian Audio Marine Radio 561 User Manual